Home Elevator

A private lift for a new villa or an existing home.

OKFIT 100 L · OKFIT 100 U

  • 250–600 kgCapacity
  • 3–8Persons
  • 150 mmPit from
A BAYERN home elevator with glass doors in a two-storey villa
A villa with a glass home lift on its side serving the roof terrace, beside the pool

Made for your home

A private lift for a new villa or an existing home, in two types. Type L travels in your own shaft, with frontal or opposite openings and up to 6 stops. Type U brings its own light steel frame with glass or solid panels, so it needs no shaft at all: a recess of 150 mm is enough. Both come with swing or automatic doors and are made to measure.

Specifications

The final quotation confirms the equipment, warranty, service coverage, response arrangements and payment terms for your project.

Models
OKFIT 100 L (in your shaft) · OKFIT 100 U (own frame)
Capacity
250–600 kg
Persons
3–8
Doors
Swing or automatic
Stops
Up to 6 (type L) · up to 5 (type U)
Pit or recess
From 150 mm
Headroom
2,700 mm minimum (type L)
Warranty
Confirmed in the project quotation
Bayern Elevator Cloud
Availability depends on the selected equipment and service agreement
Three lift car interiors: brushed gold, blue stone and warm wood
Car interiors from bayern.qa.

Before you enquire

Share what you know. You can leave unknown measurements blank; the final solution depends on a site assessment.

  • The building location and whether it is new or existing.
  • The intended use, required capacity and number of levels, where relevant.
  • Available clear dimensions, photographs or drawings, if available.
  • Access, power supply and the target project timing.
Understanding the specification
Capacity
The rated load shown for a model; the proposed load must suit the intended use.
Clear dimensions
The unobstructed space available, measured between finished surfaces.
Pit and headroom
For a shaft lift, the space below the lowest landing and above the highest landing. Confirm these against the selected model.

Request a site visit

Resources

For initial planning only. This is not a fabrication drawing or an approved project specification. Confirm the selected model, dimensions and site requirements with BAYERN.

Print / Save as PDF

Type L: in your shaft

Type L runs in a shaft of your building, with doors on one side or on two opposite sides.

Model
OKFIT 100 L
Openings
Frontal or opposite
Doors
Swing or automatic
Stops
Up to 6
Headroom
2,700 mm minimum
Warranty
Confirmed in the quotation

Type U: in its own light frame

Type U stands in its own powder-coated steel frame with glass or solid panels: no shaft to build, and a recess of just 150 mm in the floor.

Model
OKFIT 100 U
Frame
Powder-coated steel
Panels
Glass or solid
Capacity
250–320 kg
Speed
Up to 0.6 m/s
Doors
Swing or automatic
Stops
Up to 5
Recess
150 mm
Warranty
Confirmed in the quotation

Door options

For both types, L and U.

SwingCentre openingSide openingFour-panel
Clear width700–900 mm700–1,000 mm700–900 mm1,000–1,400 mm
OperationBy hand, with closerAutomaticAutomaticAutomatic
Car doorNone (open car)SlidingSlidingSliding
FinishPainted, stainless steel or vision glassPainted or stainless steelPainted or stainless steelPainted, stainless steel or glass

Swipe sideways to see the whole table.

Choose your size: type L

Pick the car, read the shaft you need. Each cell gives the shaft width × depth and the door width, in mm.

Car (inside)Load · personsFrontal, sliding doorsFrontal, swing doorsOpposite, sliding doorsOpposite, swing doors
900 × 1,200375 kg · 5On requestOn request1,540 × 1,596 · 800On request
1,000 × 800300 kg · 4On requestOn request1,640 × 1,196 · 500On request
1,050 × 709300 kg · 31,300 × 1,300 · 7001,300 × 1,120 · 8501,690 × 1,105 · 4501,330 × 1,105 · 500
1,000 × 1,000375 kg · 5On requestOn request1,640 × 1,396 · 650On request
1,100 × 1,000375 kg · 51,350 × 1,591 · 7001,350 × 1,411 · 9001,740 × 1,396 · 6501,380 × 1,396 · 800
1,200 × 1,000450 kg · 61,450 × 1,591 · 8001,450 × 1,411 · 9001,840 × 1,396 · 6501,480 × 1,396 · 800
1,200 × 1,200525 kg · 71,450 × 1,791 · 8001,450 × 1,611 · 9001,840 × 1,596 · 8001,480 × 1,596 · 900
1,400 × 900450 kg · 61,650 × 1,491 · 9001,650 × 1,311 · 9002,040 × 1,296 · 6001,680 × 1,296 · 700
1,400 × 1,000525 kg · 71,650 × 1,591 · 9001,650 × 1,411 · 9002,040 × 1,396 · 6501,680 × 1,396 · 800
1,400 × 1,100600 kg · 81,650 × 1,691 · 9001,650 × 1,511 · 9002,040 × 1,496 · 7001,680 × 1,496 · 900

Swipe sideways to see the whole table.

Other sizes are made to measure. Rated load is set by the car floor area. “On request”: a narrower shaft than our standard, ask us.

Bayern Elevator Cloud

Availability depends on the selected equipment and service agreement.

The Bayern Elevator Cloud brings monitoring, emergency support and rescue into one service. It warns us of a fault, often before it stops the lift.

  1. Your lift
  2. Sensor box
  3. The cloud
  4. Service desk
  5. Engineer

A fault alerts our desk, which sends the nearest engineer.

  • Monitoring

    A sensor box reports faults to our team.

  • Emergency support

    Contact BAYERN to confirm support availability and response arrangements.

  • Passenger rescue

    Passenger rescue arrangements depend on the equipment and agreed service coverage.

A lift with a brushed-gold car and a marble door frame

How we work

Six steps, one point of contact.

We take time to understand your space, budget and timeline before we propose anything, and we stay with you after handover.

  1. 01Listen
    Your needs, budget, timeline and who decides.
  2. 02Survey
    We visit, measure and check the structure, space and power.
  3. 03Proposal
    A drawing and a clear quote, with terms agreed together.
  4. 04Manufacture
    Built to the agreed dimensions and component specification.
  5. 05Install
    Our own team installs, tests and hands over.
  6. 06Care
    Monitoring, maintenance and follow-up for years to come.

Questions

Can you fit a lift in an existing building?

Yes. We work on finished buildings and on those still being built. A survey shows what your building needs.

What warranty do I get?

5 years on all BAYERN equipment.

Who looks after it?

Our own team, on a monthly or yearly service plan, with an emergency line day and night and a 37-minute average response.

Do you service lifts you did not install?

Yes. Maintenance, audits and repairs can be booked on their own, for any make, anywhere in Qatar.

Why install a lift at home?

Discuss access between floors, the needs of the people using the building and the available installation space.

More vertical transportation

Final specifications, price, programme, warranty and maintenance scope are confirmed in your written quotation and contract. Help & FAQs

Let’s talk

Tell us what you need. We will review the information and agree the next step with you.

Mobile / WhatsApp
6644 0248
QR code that opens a WhatsApp chat with BAYERN

Scan for WhatsApp