Passenger Elevator

Quiet rides for apartments, offices, hotels and towers.

OKFIT 200 · OKFIT 300 · V100 · V200

  • 450–2,500 kgCapacity
  • 6–33Persons
  • 0.5–2.5 m/sSpeed
A two-storey lobby with lifts on both floors, a gallery with a glass rail and people waiting
A two-storey lobby with lifts on both floors, a gallery with a glass rail and people waiting

Quiet, smooth rides for every building.

Four models cover every building, from apartments and clinics to hotels, malls and towers: OKFIT 200, OKFIT 300, V100 and V200. All run without a machine room, with automatic centre- or side-opening doors and up to 20 stops. Send us the shaft width and depth and the number of stops, and we choose the model and the largest standard car that fits.

Specifications

The final quotation confirms the equipment, warranty, service coverage, response arrangements and payment terms for your project.

Models
OKFIT 200 · OKFIT 300 · V100 · V200
Capacity
450–2,500 kg
Persons
6–33
Speed
0.5–2.5 m/s
Doors
Automatic, centre or side opening
Stops
Up to 20
Pit · headroom
1,200 · 3,600 mm minimum
Machine room
None
Structure
Your shaft, or a steel structure (shaft + 100 mm)
Warranty
As quoted

Before you enquire

Share what you know. You can leave unknown measurements blank; the final solution depends on a site assessment.

  • The building location and whether it is new or existing.
  • The intended use, required capacity and number of levels, where relevant.
  • Available clear dimensions, photographs or drawings, if available.
  • Access, power supply and the target project timing.
Understanding the specification
Capacity
The rated load shown for a model; the proposed load must suit the intended use.
Clear dimensions
The unobstructed space available, measured between finished surfaces.
Pit and headroom
For a shaft lift, the space below the lowest landing and above the highest landing. Confirm these against the selected model.

Request a site visit

Resources

For initial planning only. This is not a fabrication drawing or an approved project specification. Confirm the selected model, dimensions and site requirements with BAYERN.

Print / Save as PDF

Entrance layouts

Doors on one side, on two opposite sides, or on two sides at 90°. Opposite openings need a deeper shaft.

  • A · Frontal: doors on one side.
  • B · Opposite: front and rear.
  • C · Lateral: two sides at 90°.

Four models

Each model is drawn to the same scale in the catalogue; the example shows a typical car and the shaft it needs. Sizes in mm, clear inside.

ModelBest forCapacityPersonsSpeedDoorsExample car → shaft
OKFIT 200Apartments, offices, clinics450–1,000 kg6–131.0–1.75 m/sCentre opening1,100 × 1,400 → 1,800 × 1,820
OKFIT 300Stretchers, beds and goods: a deep car630–1,600 kg8–210.5–1.0 m/sSide opening1,000 × 1,850 → 1,600 × 2,150
V100Busy offices, hotels, malls450–1,600 kg6–211.0–2.0 m/sCentre opening1,400 × 1,500 → 2,300 × 2,180
V200Towers and heavy traffic750–2,500 kg10–331.75–2.5 m/sCentre opening1,200 × 1,500 → 2,000 × 1,800

Swipe sideways to see the whole table.

A steel structure is available for every model.

Choose your size

Pick the load, read the shaft you need. Counterweight at the side; rear drop on request. With a steel structure, add 100 mm to the shaft. Sizes in mm, clear inside.

OKFIT 200 · centre-opening doors

Load · personsCarShaftDoor
450 kg · 61,000 × 1,2501,700 × 1,670800
630 kg · 81,100 × 1,4001,800 × 1,820850
800 kg · 101,350 × 1,4002,050 × 1,8201,000
1,000 kg · 131,600 × 1,4002,300 × 1,8201,100

OKFIT 300 · side-opening doors, deep car

Load · personsCarShaftDoor
630 kg · 81,000 × 1,6001,600 × 1,900800
1,000 kg · 131,100 × 2,1001,700 × 2,400900
1,275 kg · 171,200 × 2,3001,800 × 2,6001,000
1,600 kg · 211,400 × 2,4002,000 × 2,7001,200

V100 · centre-opening doors

Load · personsCarShaftDoor
630 kg · 81,100 × 1,4002,000 × 2,080900
800 kg · 101,350 × 1,4002,250 × 2,0801,100
1,000 kg · 131,600 × 1,4002,500 × 2,0801,200
1,275 kg · 172,000 × 1,4002,900 × 2,0801,300
1,600 kg · 212,100 × 1,6003,000 × 2,2801,300

V200 · centre-opening doors

Load · personsCarShaftDoor
1,000 kg · 131,600 × 1,4002,400 × 1,7001,150
1,275 kg · 172,000 × 1,4002,800 × 1,7001,300
1,600 kg · 212,100 × 1,6002,900 × 1,9001,300
2,000 kg · 262,400 × 1,7003,200 × 2,0001,300
2,500 kg · 332,400 × 2,0003,200 × 2,3001,300

Rated load follows the car floor area. Opposite openings need a deeper shaft.

Bayern Elevator Cloud

Availability depends on the selected equipment and service agreement.

The Bayern Elevator Cloud brings monitoring, emergency support and rescue into one service. It warns us of a fault, often before it stops the lift.

  1. Your lift
  2. Sensor box
  3. The cloud
  4. Service desk
  5. Engineer

A fault alerts our desk, which sends the nearest engineer.

  • Monitoring

    A sensor box reports faults to our team.

  • Emergency support

    Contact BAYERN to confirm support availability and response arrangements.

  • Passenger rescue

    Passenger rescue arrangements depend on the equipment and agreed service coverage.

A lift with a brushed-gold car and a marble door frame

How we work

Six steps, one point of contact.

We take time to understand your space, budget and timeline before we propose anything, and we stay with you after handover.

  1. 01Listen
    Your needs, budget, timeline and who decides.
  2. 02Survey
    We visit, measure and check the structure, space and power.
  3. 03Proposal
    A drawing and a clear quote, with terms agreed together.
  4. 04Manufacture
    Built to the agreed dimensions and component specification.
  5. 05Install
    Our own team installs, tests and hands over.
  6. 06Care
    Monitoring, maintenance and follow-up for years to come.

Questions

Can you fit a lift in an existing building?

Yes. We work on finished buildings and on those still being built. A survey shows what your building needs.

What warranty do I get?

5 years on all BAYERN equipment.

Who looks after it?

Our own team, on a monthly or yearly service plan, with an emergency line day and night and a 37-minute average response.

Do you service lifts you did not install?

Yes. Maintenance, audits and repairs can be booked on their own, for any make, anywhere in Qatar.

Why install a lift at home?

Discuss access between floors, the needs of the people using the building and the available installation space.

More vertical transportation

Final specifications, price, programme, warranty and maintenance scope are confirmed in your written quotation and contract. Help & FAQs

Let’s talk

Tell us what you need. We will review the information and agree the next step with you.

Mobile / WhatsApp
6644 0248
QR code that opens a WhatsApp chat with BAYERN

Scan for WhatsApp